[. . . ] 13 2 IT DOUBLE DOOR CONTROL PANEL The thermostat box to control the appliance is located inside the fridge compartment on the top right. [. . . ] Make sure foods do not touch the back or sides of the fridge compartment NB. If you need to contact our Service Department in the event of faults, remember to give them the information on the plate. Important: If the room temperature is very warm, the appliance may work continuously and a layer of frost will deposit on the back of the fridge compartment. REVERSING THE OPENING OF THE DOORS In order to reverse the opening of the doors, follow the indications in relation to the insert and hinge type your product is made up of. A Place or tilt the fridge at a 45° angle, since it is necessary to work on the bottom of the appliance Remove the bottom hinge by removing the screws, the plug and washers, then remove the bottom door Remove the middle screw and remove the top door 1 2 3 3 EN Remove the caps (A) and (B), loosen the screws and partially remove the panel. Unscrew the right hinge 4 5 Mark and break the left-hand slot on the panel, in the insert area 6 Flip the top left-hand hinge found in the accessories kit 7 Remove the plug on the left-hand side and insert it on the right hand-side of the central and lower inserts. [. . . ] 1 2 3 To reverse the handles: Remove the outer caps from the right-hand side of the doors 10 11 12 Unscrew the handles from the left hand-side and move them to the right hand-side of the product. [. . . ]